ScientificJournals.com  

LCA

LCA Methodology with Case Study



Integration of Life Cycle Assessment and Population Balance Model for Assessing Environmental Impacts of Product Population in a Social Scale. Case Studies for the Global Warming Potential of Air Conditioners in Japan (8 pp)
Kazuhiko Yokota; Yasunari Matsuno; Masaru Yamashita; Yoshihiro Adachi
Corresponding author:: Prof. Dr. Yasunari Matsuno, Department of Materials Engineering, Graduate School of Engineering, The University of Tokyo, 7-3-1 Hongo, Bunkyo-ku, Tokyo 113-8656, Japan (matsuno@material.t.u-tokyo.ac.jp)

Abstract Request for single articles 218 KB  Full paper
64 downloads since April 2003

DOI: http://dx.doi.org/10.1065/lca2003.04.112

SCOPE. In this study, a dynamic model was built in which LCA and PBM were integrated to quantitatively assess the total environmental impacts induced by the product population in a society over time. Specifically, a determination was carried out concerning how Japans air conditioner population is used (lifetime distribution, number of units, etc.) and an assessment was made concerning the Global Warming Potential (GWP) associated with the air conditioner population.

METHODS. The proposed dynamic model was applied to air conditioners for analyzing the total GWP caused by the air conditioner population in Japan from 1990 to 2010. To create a trend forecast model for future environmental load, scenarios for air conditioner production up to 2010 were formulated and the total GWP from the air conditioner population was predicted. Conducted also were sensitivity analyses whose parameters were air conditioner performance, lifetime and the rate of refrigerant recovery when retired units are processed.

RESULTS AND DISCUSSION. Applying the PBM to the air conditioner population in 2000, it was found that 81.5 million units consumed 5.94 x 1010 kWh in that year, which was a 6.1% increase in the total annual power consumption in 1990. In both a stationary scenario and a steady growth (1.5% annual increase), it was found that the total GWP would be 27.7% higher than in 1990 under the stationary scenario and 37.8% higher under the steady growth scenario. The improvements in air conditioner performance will have a small effect on reducing the total GWP from that population. Furthermore, in connection with the average lifetime, it was found that the GWP, due to refrigerant releases when units are disposed of, would be relatively large in 2000 and the following years.

CONCLUSIONS. Thus, shorter product lifetimes will spur a replacement of air conditioners with new units, a situation that will only lead to the reduction of GWP if the recovery rate of refrigerant is to be achieved to more than 50% under the stationary scenario.

RECOMMENDATIONS AND OUTLOOK. To meet COP3 targets for Japan in 2010 (i.e. to reach the same level as in 1990 for household appliances), our study shows that it will be vital to raise the refrigerant recovery rate. If the number of air conditioners in use remains unchanged, recovery would have to be 45.7%, but under the steady growth scenario it would have to be at least 60.4%. Therefore, it will be difficult to meet COP3 targets unless the refrigerant recovery rate is strongly increased. This method is applicable to assess not only the GWP of air conditioners, but also other environmental impacts caused by a variety of product populations, which will be quite effective for setting targets of products" performance, policymaking, etc.

8 LCA (3) 129-136 (2003)

Development: Enterprise Technologies